remove ASG_id and ASG_Serial lines):Īs you see UTM and SG’s have different LCD controller. The main reason it does not work, is that the /etc/asg file is now missing, because this file tells the installer that it is running on an appliance, you cannot copy this from another appliance solely, because you need to modify it (Ex. There have been written a lot here about a fix:īut the link above does only make the display work with one view “Sophos UTM %version% and uptime”, this is due to the missing /etc/lcd.data file, because this file is only generated on appliances (hardware install). Install will proceed as normal, but after install, the LCD display will no longer work, cause it’s now a “software” install and not hardware appliance install. a SSD or other drive, the hardware installer will not install, due to hardware replacement (It looks for specific harddrives with special firmware!), then you cannot use the installer above, you will then have to go with the SOFTWARE ISO instead of the HARDWARE ISO. This workaround will not swap interface names, and if you have one of the bigger models, 220 and beyond, with LCD, then will this just work as it did with hardware config – software installations do not have support for the LCD driver – but this way it works. Now the UTM will boot running software license, and you can use your home license with it □ At the login prompt: login as root – it will tell you to change password, just do that (Old password is ).ĭelete the “ASG_ID….”-entry in the file and save and close.Connect a VGA screen and a USB keyboard to the appliance.After installation, you now have a complete clean Sophos UTM 9 installation.Install the hardware appliance as you would do normally.Burn this to a CD-rom or to USB following this link. (This will format the harddrive of the appliance, so logs and stats are lost!).Download the hardware image for appliances, theese starts with “SSI” in the file name.Take a backup of your running UTM configuration in WebAdmin, if you have such running at the moment.This can be “solved”, by making the hardware installation think, it’s going software □ UTM 220, 320 etc, you cannot use this in your home environment (With your free home license), without paying for a hardware license. Normally when you get an old hardware Appliance, ex. In addition, the browser must be configured not to use a proxy for the IP address of Sophos UTM on AWS’s internal network card (eth0).This is not a supported configuration by Sophos □ Browser: Sophos UTM on AWS requires the latest version of Firefox (recommended), latest version of Chrome, latest version of Safari, or last two versions of Microsoft Internet Explorer.Processor: Clock signal frequency 2 GHz or higher.The hardware and software requirements for the client PC used to access WebAdmin are as follows: To make the installation and operation of Sophos UTM on AWS Software less error-prone, you are advised to only use hardware that is listed in the HCL. The Hardware Compatibility List (HCL) is available at the Sophos Knowledge Base. Sophos provides a list of hardware devices compatible with Sophos UTM on AWS Software. ![]() Note that this switch must have jumbo frame support enabled.
0 Comments
Leave a Reply. |